Installing the VVT Bypass II
VVT Bypass II Controller
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
19
Linked actuators
You can wire up to 4 of the following Belimo actuators to the VVT Bypass II's analog output. Link actuators
whose travel times and other parameters coincide.
LMX24-MFT P-10028
45 in.-lb (5 Nm) actuator with 0–10 Vdc control
NMX24-MFT P-10028
90 in.-lb (10 Nm) actuator with 0–10 Vdc control
AMX24-MFT P-10028
180 in.-lb (20 Nm) actuator with 0–10 Vdc control
1
Install the actuators according to the manufacturer's instructions.
2
Wire the actuators to the controller using the diagram below.
3
Set the direction rotation switch on each actuator to CW.
NOTE
Maintain polarity if using the same power supply for more than one actuator.
Summary of Contents for VVT Bypass II
Page 51: ......
