Installing the VVT Bypass II
VVT Bypass II Controller
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
10
CAUTIONS
○
You
must
use the screws, anti-rotation slot's bushings, and o-rings that are shipped with the VVT Bypass
II.
○
Overtightening the screws so that the controller and actuator cannot move may damage the unit.
4
Hold down the controller’s damper release button and rotate the actuator clamp in the same direction that
closed the damper. Rotate the clamp until it stops, then rotate it back one notch.
5
Release the button.
6
Tighten the actuator clamp to the damper shaft by tightening the two M5 nuts.
Summary of Contents for VVT Bypass II
Page 51: ......