Installing the VVT Bypass II
VVT Bypass II Controller
CARRIER CORPORATION ©2019
Installation and Start-up Guide
All rights reserved
8
Disconnect the actuator from the controller by inserting a screw driver in the slot on the back of the VVT Bypass II
and pressing the tab. The actuator cable or an attached extension cable must connect to the controller's
Act Net
port.
1
Turn the damper shaft to fully close the damper.
2
Mount the controller to the VVT terminal by sliding the clamp assembly onto the damper shaft.
Summary of Contents for VVT Bypass II
Page 51: ......