2--16
62--11161
2.2.8 Crankshaft
2.2.8.a Flywheel
1. Position the flywheel (2) so that the “1TC” mark (a) on
the outer surface of the flywheel aligns horizontally
with the alignment mark (b) on the rear end plate.
2. Prevent the flywheel (2) from rotating.
3. Remove all of the flywheel screws (1).
4. Remove the flywheel (2).
When Reassembling
Check to see that the mating surfaces of the crankshaft
and flywheel are clean.
Align the “1TC” mark (a) on the outer surface of the
flywheel horizontally with the alignment mark (b) on the
rear end plate and install the flywheel
Apply engine oil to the flywheel bolts and install.
Tightening
Torque
Flywheel Bolts
53.9 to 58.8 N
.
m
5.5 to 6.0 kgf
.
m
39.8 to 43.4 ft--lbs
1. Flywheel Bolt
2. Flywheel
a 1TC Mark
b Alignment Mark
2.2.8.b Bearing Case Cover
1. Remove the bearing case cover mounting bolts. First,
remove the inside bolts (1) and then the outside
screws (2).
2. Screw two of the removed bolts into the bolt hole of
the bearing case cover (6) to remove it.
NOTE
The length of the inside and the outside bolts
are different. When reassembling reinstall the
appropriate bolt in the correct location.
When Reassembling
Fit the bearing case gasket (3) and the bearing case
cover gasket (4) to the bearing case cover (6). Orient
them correctly.
Install the bearing case cover (6), again orienting it
correctly, using the “UP” mark (a).
Apply oil to the oil seal, and take care that it is not rolled
while being installed.
Tighten the bearing case cover bolts diagonally and
evenly.
Tightening
Torque
Bearing Case
Cover Mounting
Screw
9.8 to 11.3 N
.
m
1.00 to 1.15 kgf
.
m
7.2 to 8.3 ft--lbs
1. Bearing Case Cover
Mounting Bolt (Inside)
2. Bearing Case Cover
Mounting Bolt (Outside)
3. Bearing Case Gasket
4. Bearing Case Cover Gasket
5. Oil Seal
6. Bearing Case Cover
(
a
).Top Mark “UP”
(
b
) Upside
