2--6
62--11161
2.2.5 Oil Pan and Oil Pick--up Screen
(1)
CT2--29--TV
(2)
(1)
CT3--44--TV
(3)
(4)
(3) (2)
Sealer Location
1. Remove the oil pan mounting bolts.
2. Remove the oil pan by lightly tapping the side of the
pan with a soft hammer.
3. Scrape off the old adhesive from the mating surfaces
of the oil pan and the engine block completely.
4. Remove the oil pick--up screen (1).
5. Clean and Inspect the oil pick--up screen (1) for dam-
age.
6. Visually inspect the oil pick--up screen O--ring (4) for
damage, oil it and reinstall.
7. CT2--29--TV engine, use hole labeled 2, CT3--44--TV
engine, use hole labeled 3 to install the pick--up
screen mounting bolt.
8. Apply gasket cement (sealer) so that the sealer is
about 3 to 5 mm (0.12 to 0.20 in.) thick around the
flange of the oil pan. Apply the sealer on the center of
the flange as well as on the inner wall of each bolt
hole.
9. Within 20 minutes after the application of the sealer,
replace the oil pan and mounting bolts.
NOTE
Refer to Section 1.4 for proper torque values on
all fasteners.
