2--10
62--11161
2.2.6 Timing Gear, Camshaft and Fuel Camshaft (Continued)
2.2.6.c Fan Drive Pulley
1. Secure the flywheel to keep it from turning.
2. Remove the fan drive pulley bolt.
3. Remove the fan drive pulley with a puller.
When Reassembling
Install the pulley to the crankshaft, aligning the mark (1)
on them.
Apply engine oil to the fan drive pulley retaining bolts
and tighten them.
Tightening
Torque
Fan Drive Pulley
Screw
117.7 to 127.5 N
.
m
12.0 to 13.0 kgf
.
m
86.8 to 94.0 ft--lbs
2.2.6.d Gear Case
1. Disconnect the start spring (2) from the fork lever 1
(3).
2. Remove the bolt (1) inside the gear case.
3. Remove the remaining bolts securing the gear case
to the engine block.
4. Remove the gear case.
When Reassembling
Apply a gasket sealer to both sides of the gear case
gasket.
Be sure the three O--rings in the gear case are in place.
1. Bolt (Inside)
2. Start Spring
3. Fork Lever 1
4 Gear Case
