Carrier CDN-10Q7, Owner'S Manual

Page: 14 / 98

CONTROL PADS ON THE DEHUMIDIFIER IDENTIFICATION OF PARTS
12
Indicator lights
1
Continuous dehumidifying mode light;
2
Bucket full light;
3
POWER light;
Control pads
4
Power Pad
Press to turn the dehumidifier on and off. It illuminates
when the unit is switched on and turns dark when the unit is
switched off. When Humidity/Temperature sensor malfunction
occurs, the power light blinks at 5 times per second.
5
Up/Down pads
● Humidity Set Control Pads The humidity level can be
set within a range of 35%RH(Relative Humidity) to
85%RH(Relative Humidity) in 5% increments.
For drier air, press the pad and set to a lower percent value
(%).
For damper air, press the pad and set a higher percent value
(%).
6
Continue pad
Select for the dehumidifier to operate continuously for
maximum dehumidification until the bucket is full. The
Humdity set control pads cannot be used when Continuous
operation is on. Press this pad again to cancel Continuous
operation and enter dehumidifying mode.
7
LED Display
Shows the set % humidity level from 35% to 85%, then
shows the actual (5% accuracy) room % humidity level in a
range of 30% RH (Relative Humidity) to 90%RH (Relative
Humidity).
Error Codes:
ES- Tube temperature sensor error;
AS- Room temperature sensor error;
Protection Codes:
P2- Bucket is full or bucket is not in the right position --
Empty the bucket and replace in the right position.
Note: When one of the above malfunctions occurs, turn off
the unit, and check for any obstructions. Restart the unit, if
the malfunction is still present, turn off the unit and unplug the
power cord. Contact the manufacturer or its service agents
or a similar qualified person for service. When reading the
humidity level, please look right at the LED display window.
1 2 3 4
5
5
6
7
Fig.1
CONTROL PADS ON THE DEHUMIDIFIER
GB