Carlton SP8018 TRX, Owner'S Manual

Page: 61 / 101

SP8018 TRX SERVICING CUTTER WHEEL
41
TOOTH ARRANGEMENT
•
Inspect pockets, teeth, and bolts for damage
and replace as required.
•
When replacing pockets, always replace
new pockets across from each other in
order to prevent vibration.
•
Replacement teeth must be carbide tipped
and have like design as provided with the
machine.
•
Use anti-seize on threads to prevent bolts
from “freezing up” in cutter wheel pockets.
•
When replacing complete set of teeth, be
sure to duplicate original factory tooth
arrangement.
•
Torque bolts to 150 ft/lbs.
opposing outside pockets carry like arrangements of teeth to cancel vibration
•
Straight teeth are mounted in TWO
OPPOSING OUTSIDE POCKETS.
•
A straight tooth must have a 45° tooth
accompanying it in the same pocket set.
The opposite pocket set should have this
same combination of straight and 45° teeth,
except with positions reversed. Mounting
these teeth opposite each other on the
cutting wheel cancels damaging vibration.
•
Two Other Opposing Outside Pockets, as
shown, must have 45° teeth overlapping
centerline of wheel to make plunge cuts
possible. Mount two left 45° teeth opposite
two right 45° teeth.
•
All remaining outside pockets and all
inside pockets require 45° teeth mounted
away from the wheel.
•
The second pocket in each group gradually
goes back into the cutter wheel for half a
rotation and then repeats.