Carlton SP8018 TRX, Owner'S Manual, Page: 37 / 101

SP8018 TRX MACHINE CONTROLS
17
SAFETY
•
NEVER SERVICE A MACHINE WITH THE ENGINE RUNNING, SEVERE
PERSONAL INJURY COULD OCCUR. TURN ENGINE OFF THEN REMOVE
IGNITION KEY AND DISCONNECT POSITIVE BATTERY CABLE TO AVOID
STARTING MACHINE ACCIDENTALLY.
•
CUTTER WHEEL MUST BE DISENGAGED BEFORE TURNING ENGINE
ON/OFF AND BEFORE SERVICING A MACHINE. OTHERWISE SEVERE
PERSONAL INJURY COULD OCCUR AS WELL AS MACHINE DAMAGE.
•
ALL MACHINE PARTS MUST COME TO A COMPLETE STOP AND HAVE
TIME TO COOL COMPLETELY BEFORE SERVICING A MACHINE OR
SEVERE INJURY COULD OCCUR, POSSIBLY SERIOUS BURNS AND/OR
DISMEMBERMENT.
•
PLACE THE CUTTER WHEEL ON THE GROUND WHEN PERFORMING
SERVICE ON A MACHINE.
PROGRAMMING – RADIO
(WIRELESS) TRANSMITTER
•
If there is a problem with the receiver or the
transmitter and either has to be replaced, you
will need to program the new unit to
communicate with the existing unit. Or if
you have more than one transmitter for this
machine, it will need to be programmed to
communicate with the existing receiver.
•
To program the transmitter and receiver, you
have to download the transmitter’s unique
code into the receiver. There are complete
instructions along with colored illustrations
in the radio control manual included in the
back of this manual.
•
To access the receiver, remove the front
cover from the machine control box.
•
Remove the cover of the remote receiver
with the radio receiver attached. This will
make it easier to work with the radio
receiver. Remove the radio receiver panel
by unlatching the plastic tabs on either side
of the receiver; see the radio control manual
included in this manual at the back. The
receiver panel will now slide out of the cap.
•
Follow the instructions in the radio control
manual, included at the end of this manual,
to download the ID Code. There are
specific instructions that need to be followed
and corresponding illustrations.
REMOVE THE REMOTE
COVER TO ACCESS THE
RADIO RECEIVER UNIT
RELEASE THE RADIO
RECEIVER CAP BY
UNLATCHING THE
TABS ON EACH SIDE
REMOVE
COVER
BE SURE TO PUSH THE RECEIVER PANEL BACK UP INTO
THE COVER UNTIL THE TABS SNAP BACK INTO PLACE.