Carlton SP8018 TRX, Owner'S Manual, Page: 44 / 101

SP8018 TRX MACHINE OPERATION
24
•
Raise cutter wheel clear of stump and
return to center position.
•
Reduce engine speed to idle. DO NOT
TURN OFF MOTOR. Engine must be
allowed to cool slowly at idle for 3-5
minutes to avoid damage.
•
With engine at idle; disengage drive
belts by pushing and holding the belt
switch down until the actuator pushes
the clutch arm all the way to the stop.
•
ENGINE SPEED MUST BE AT IDLE
TO ENGAGE OR DISENGAGE THE
CLUTCH OR DAMAGE WILL
OCCUR.
•
After cutter wheel has come to a
complete stop, turn the machine around
and you can move the pile of chippings
around using the blade that comes with
the SP8018 TRX.
•
Turn off motor. Allow cutter wheel to
come to a full stop before inspecting
work area.