Carlton SP8018 TRX, Owner'S Manual, Page: 32 / 101

SP8018 TRX MACHINE CONTROLS
12
•
Use the radio transmitter to operate the
machine when positioning the machine
at the job site and when grinding the
stumps. The five operation and
positioning functions operate the same
on the machine as on the radio
transmitter. The radio transmitter has a
sixth control switch that will move both
of the tracks at the same time in the
forward or reverse directions only.
There is also a switch to control the Gear
and Flow on the radio transmitter. See
Hydraulic Controls listed in this section
for more information.
•
The E-STOP button turns off the
transmitter and the machine when it is
pressed down.
•
To run the machine by the toggle
switches, put the machine switch in the
Machine On position and turn the key
switch while pressing the by-pass switch
to start. The machine-mounted controls
can now be operated but not the radio
control.
•
The machine-mounted controls are
toggle switches and automatically go
back to the off position in the middle
when released. These switches can be
used for short-term operation to position
the machine or to test the operation of
the functions. DO NOT GRIND
STUMPS USING THE MACHINE
MOUNTED CONTROLS, INJURY
COULD OCCUR.
PUSH SWITCH DOWN
TO MACHINE ON