Rev.00 - 06.2021 | MAN PD30CTB IO-Link EN | © 2021 |
CARLO GAVAZZI Industr6
30
EN
2) Dynamic teach command sequence:
Buttons are found in menu: “Teach-in Dynamic SSC1” or “Teach-in Dynamic SSC2” -> “Teach-in”
1. Move the target to the position for SP1
A. Press “Teach SP1 Start “.
B. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
C. Press “Teach SP1 Stop “
D. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
2. Move the target to the position for SP2
A. Press “Teach SP2 Start “.
B. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
C. Press “Teach SP2 Stop “
D. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
3. Teach-in Result.Teach-in state = e.g. “SUCCESS”
4. QoT is shown in “Quality of Teach” e.g. 100 %
2.6.2.2. Two point mode procedure
1) Two value teach command sequence:
Buttons are found in menu: “Teach-in SSC1” or “Teach in SSC2” -> “Teach-in Two value SSC1”
or “Teach-in Two value SSC2”
1. Move the target to the position for SP1 TP1
A. Press “Teach SP1 TP1”
B. “Teash-in Result.TeachPoint 1 of Set Point 1” = e.g. “OK”
C. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
2. Move the target to the position for SP1 TP2
A. Press “Teach SP1 TP2”
B. “Teash-in Result.TeachPoint 2 of Set Point 1” = e.g. “OK”
C. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
3. Move the target to the position for SP2 TP1
A. Press “Teach SP2 TP1”
B. “Teash-in Result.TeachPoint 1of Set Point 2” = e.g. “OK”
C. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
4. Move the target to the position for SP2 TP2
A. Press “Teach SP2 TP2”
B. “Teash-in Result.TeachPoint 2 of Set Point 2” = e.g. “OK”
C. Teach-in Result.Teach-in state = e.g. “WAIT FOR COMMAND”
5. Press Teach Apply
A. Teach-in Result.Teach-in state = e.g. “Success”
6. QoT is shown in “Quality of Teach” e.g. 100 %
Sensor
Sensing distance
ON
OFF
SP2
SSC
TP2
TP1
SP1
TP1
TP2
