CP3 version 3003
73
In the below drawing we have an example where two sensors marked “A” are programmed as entrance
sensors and the opposite sensors marked “B” are programmed as exit sensors.
It is possible to increase the number of sensors for group A and B to ten sensors in total. Five sensors for
each group. Please refer to the software manual available here:
http://www.productselection.net/MANUALS/UK/cp3_manual.pdf
In the example below: if two cars are passing the sensors at the same time, the MZC will not count
correctly, because, when activated, the MZC cannot determine if the car is going in or out. However,
placing the DPO close to a cross section, corner or another place where the drivers will automatically slow
down or be patient, this phenomenon will seldom appear.
Sensors 1, 4, 6 are programmed as input sensor and sensor 2, 3, 5 as output sensors.
Maximum 5 sensors as B
Maximum 5 sensors as A