CP3 version 3003
56
Manual Calibration
The manual calibration is performed in situations where the installer needs to calibrate only one or a few
sensors. This is often the case in situations where a single sensor has become defective for an unknown
reason.
The manual calibration also makes it possible for the installer to press a button on the sensor that executes
the calibration procedure.
Follow the same basic procedure as under “Automatic calibration” for the 3 first steps.
Select sensor (or sensors) to be calibrated
Select “Mounting” (
Lane
or
Over the Car
) for the sensor(s)
Select “Distance” (measure the distance vertically from sensor to floor in meter) and insert the
distance for the sensor(s)
Change the red cross on “Enable push button for calibration” to green checkmark and press “Send
command”
Go to the sensor and press the button
o
Response from sensor: Sensor will start flashing yellow slowly in 15 sec. The sensor changes
to fast yellow flashes for 5 sec. and finally it calibrates in 3 sec. with flashing green LEDs
Select “Write data” to enter the data of the selected sensor or sensors