MAINTENANCE
EN
AH-13-01-R8 (09/2022)
28 / 55
www.carlisleft.com
Figure 17: High Voltage Cable and Electric Motor Removal Diagram
CABLE/ ELECTRIC MOTOR
ASSEMBLY
1. Remove the (4) socket head screws from the rear of the
applicator using a 9/64” hex key wrench.
2. Remove the two slot headed screws from the assembly.
3. Pull the high voltage cable assembly straight out of the
assembly. The spacer, the gasket and the electric motor
will also pull out of the barrel.
Item #
1
2
3
4
5
6
HIGH VOLTAGE CABLE AND ELECTRIC MOTOR REMOVAL DIAGRAM
(Figure 17)
Description
(4) Socket Head Screws
(2) Slotted Head Screws
High Voltage Cable Assembly
Switch
Gasket
Electric Motor Assembly
4. Inspect gasket for any damage. Replace if required.
5. Check the applicator end of the cable assembly to ensure
the spring is attached to the cable. Apply a generous
coating of di-electric lubricant (LSCH0009-00) to the
applicator end and the power supply end of the high
voltage cable.
6. Attach the motor to the cable assembly using the (2)
slotted screws and the air inlet slide valve assembly
7. Slide the entire assembly into the barrel insuring the cable
end and all other parts are properly positioned. Insert the
(4) socket head screws and tighten only by hand.
2
1
3
6
4
5