INTRODUCTION
EN
AH-13-01-R8 (09/2022)
10 / 55
www.carlisleft.com
INTRODUCTION
GENERAL DESCRIPTION
This is a method of applying electrostatically atomized
coating material. The No. 2 Electric Process Handgun
system applies a high voltage, DC negative charge to
the applicator bell, creating an electrostatic field between
the bell and the target object. The target is electrically
grounded through its support (which may be stationary or
moving) or through an electrical connection to a known
earth ground.
A regulated pressure fluid system delivers coating material
to the electric motor driven bell when the gun is triggered.
There, the fluid travels across the face of the rotating bell
and is charged. The fluid is atomized at the edge of the
bell forming a fine mist, which under the influence of the
electrostatic field is attracted to and deposited on the
target object. The forces between the charged particles
and the grounded target are sufficient to turn most normal
overspray around and deposit it on the rear surface of
the target. Therefore, most of the spray is deposited
and overspray is controlled. This process makes the
No. 2 Electric Process Handgun one of the most efficient
electrostatic spray products on the market.
The No. 2 Electric Process Handgun applies a DC negative
charge to the coating materials at the point of atomization.
The electrostatic charge allows a more efficient, uniform
application of coating material to the front, edges, sides,
and back of products, making it highly suitable for applying
coatings to a variety of surface configurations; large targets,
tubular products, small parts, fencing, etc. Because it is a
grounded fluid system, it is highly suitable for applying a
wide range of solvent reduced coatings such as enamels,
epoxies, etc.
One of the many features of the No. 2 Electric Process
Handgun is that the electrical discharge, which is available
from the resistive charging brush, is limited to the optimum
combination of safety and efficiency.
The No. 2 Electric Process Handgun system includes
the Hand Gun, the High Voltage Power Supply, the High
Voltage Cable, and Fluid Hose.
This unit contains the 19372-XX No. 2 handgun electric
motor version and the 80102-21X 9060 power supply
along with several required accessories. Below illustrates
the ordering matrix available.
19372 - AA U No. 2 Electric Motor
Indicates Cable Length
Indicates Unit
AA is:
25’
(7.6 m) Cable Length
36’
(11 m) Cable Length
50’
(15.2 m) Cable Length
75’
(22.9 m) Cable Length
100’
(30.4 m) Cable Length
U=N
Gun Only
U=U
110V Power Supply (80102-211)
U=E
220V Power Supply (80102-212)