Carl Valentin VARIO III series, Quick Reference Manual

Page: 92 / 185

Vario III
92 English
Loading label roll in tear-off mode
•
Open the printer cover.
•
Open printhead (F) by turning the pressure lever (H) anticlockwise.
•
Remove the outside label mounting plate (A).
•
Load the label roll with inner winding onto the unwinding roll (B) and attach again the label mounting plate (A).
•
Lead the label material below the label guiding (D).
Pay attention that the label runs through the photocell (E).
•
In order to move the printhead (F) down, turn the pressure lever (H) in clockwise direction until it locks.
•
In front of the printhead you can see the tear off (G) from which you can rip off labels to the bottom.
•
Enter the offset value in the menu Print settings/Tear off .
•
Adjust the limit stops (C) of the label guiding to the width of material.
•
Close the printer cover.