Carl Valentin Vario II series, Quick Reference Manual

Page: 85 / 171

Vario II
English 85
Loading label roll in rewind mode
In rewind mode the labels are wound up internally after printing for later use.
•
Open the printer cover.
•
Open printhead (A) by turning the pressure lever (B) anticlockwise.
•
Remove the outside label mounting plate (C).
•
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting plate (C).
•
Lead the label material below the label guiding (E).
Pay attention that the label runs through the photocell (F).
•
Place the labels around the front sheet (G) and lead them below the mechanics to the rear.
•
Clamp the label material, with the handle (H) designated for it, at the rewinding roll (I).
•
In order to move the printhead (A) down, turn the pressure lever (B) in clockwise direction until it locks.
•
Adjust the limit stops (J) of the label guiding to the width of material.
•
Close the printer cover.