Carl Valentin Vario II series, Quick Reference Manual

Page: 86 / 171

Vario II
86 English
Loading label roll in tear-off mode
•
Open the printer cover.
•
Open printhead (A) by turning the pressure lever (B) anticlockwise.
•
Remove the outside label mounting plate (C).
•
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting plate (C).
•
Lead the label material below the label guiding (E).
Pay attention that the label runs through the photocell (F).
•
In order to move the printhead (A) down, turn the pressure lever (B) in clockwise direction until it locks.
•
In front of the printhead you can see the tear off (G) from which you can rip off labels to the bottom.
•
Enter the offset value in the 'Printer Initialisation/Tear off''.
•
Adjust the limit stops (H) of the label guiding to the width of material.
•
Close the printer cover.