Carl Valentin Vario II series, Quick Reference Manual

Page: 89 / 171

Vario II
English 89
Key:
Y displacement:
Indication of initial point displacement in mm. The label is moved vertically.
Value range:
−30.0 to +90.0.
Key:
X displacement:
Indication of displacement in X direction. The fields on the label are moved.
Value range:
−90.0 to +90.0.
Key:
Tear off:
The standard value of tear off offset is 7,5 mm. Value range: 0 to 50.0 mm.
Key:
Column printing:
NC: Indication of number of columns that are placed side by side on the backing paper.
CW: Indication of column width.
Key:
External parameters:
On:
Sending parameters such as print speed and contrast via our label creation software
to the printer. Parameters which are set directly at the printer before are no longer
considered.
Off: Only settings made directly at the printer are considered.
Key:
Measure label automatically:
On:
After switching on the printer, the loaded label is automatically measured.
Off: In order to start the measurement procedure you have to change to the
corresponding menu.
Print mode
Keys: , , ,
Key:
Type of label:
Generally adhesive labels are set. In case you would like to use continuous labels, you
have to select this in the menu.
Key:
Flip label:
The axis of reflection is in the middle of the label. If the label width was not transferred to
the printer, automatically the default label width i.e. the width of the printhead is used. It
is recommended to use labels with the same width as the printhead. Otherwise this can
cause problems in positioning.
Key:
Rotate label:
According to standard the label is printed ahead with a rotation of 0°. If the function is
activated, the label is rotated by 180° and printed in reading direction.
Key:
Transfer ribbon control:
Examination if the ribbon roll is to end or if the ribbon was torn at the unwinding roll.
Off: The ribbon control is deselected, i.e. the printer continues without an error message.
On: The ribbon control is selected, i.e. the current print order is interrupted and an Error
Message appears at the printer display.
strong sensibility: The printer reacts immediately to the end of the transfer ribbon.
weak sensibility: The printer reacts approx. 1/3 more slowly to the end of the ribbon.
Key:
Dispenser mode:
To operate the printer in dispensing mode a print order has to be started and the printer
has to be in 'waiting' mode.
By means of key you can switch to the next operating mode
Key:
Cutter mode:
Selection of the desired operating mode.