SPX II Series
Safety Instructions
03.17
Operating Manual
7
2
Safety Instructions
The print module is designed for power supply systems of
110-230V. Connect the print module only to electrical outlets with a
ground contact.
NOTICE!
When changing the mains voltage the fuse value is to adapt
accordingly (see Technical Data).
Couple the print module to devices using extra low voltage only.
Before making or undoing connections, switch off all devices involved
(computer, printer, accessories etc.).
Operate the print module in a dry environment only and do not get it
wet (sprayed water, mist etc.).
Do not operate the print module in explosive atmosphere and not in
proximity of high voltage power lines.
Operate the print module only in an environment protected against
abrasive dust, swarf and other similar impurity.
If the direct print module is operated with the cover open, ensure that
clothing, hair, jewellery and similar personal items do not contact the
exposed rotating parts.
NOTICE!
With the open printing unit (due to construction) the requirements
of EN60950-1 regarding fire protection casing are not fulfilled.
These must be ensured by the installation into the end device.
The print unit can get hot during printing. Do not touch the printhead
during operation. Cool down the print unit before changing material,
removal or adjustment.
Carry out only the actions described in these operating instructions.
Any work beyond this may only be performed by the manufacturer or
upon agreement with the manufacturer.
Unauthorized interference with electronic modules or their software
can cause malfunctions.
Other unauthorized work or modifications to the print module can
endanger operational safety.
Always have service work done in a qualified workshop, where the
personnel have the technical knowledge and tools required to do the
necessary work.
There are warning stickers on the print modules that draw your
attention to dangers. Therefore the warning stickers are not to be
removed as then you and others cannot be aware of dangers and may
be injured.
The printing unit must be integrated with the Emergency Stop circuit
when it is incorporated into the overall machine.