SPX II Series
Maintenance and Cleaning
03.17
Operating Manual
81
9.7 Replacing the Printhead
C
B
A
A
Figure 19
1. Remove labels and transfer ribbon.
2. When printhead is closed, loosen the knurled screws (A).
3. Turn red lever (C) counter clockwise to lift up the printhead.
4. If the printhead (B) is not disengaged on the pressure roller,
continue loosen the knurled screws (A).
5. Remove the printhead carefully to the front until you can reach the
plug connections.
6. Remove plug connections and then remove printhead (B).
1. Attach plug connections.
2. Position printhead (B) in the intermediate layer in such a way that
the printhead drillings correspond with the appropriate drillings in
the intermediate layer.
3. Lightly keep printhead mounting bracket on the printer roller with
one finger and check for correct positioning of the printhead.
4. Screw in the knurled screws (A) and tighten them.
5. Reload labels and transfer ribbon (see chapter 5 Loading Media,
page 29).
6. Check resistance value on the type plate of printhead and if
necessary change the value in the menu
Service functions/Heater
resistance
.
Removing the
printhead
Installing the
printhead