SPX II Series
Additional Information
03.17
Operating Manual
101
Peel off:
After printing the label it is driven into the dispensing
offset and there waited. When releasing a new start
signal (IO dynamic) then the next label is immediately
printed. Because of the fact that the label is already in
the offset, the label is only printed from beginning of
offset position, i.e. at the definition of label an
accordingly large range must be left free at the top
margin of label, because these data are otherwise not
printed.
Cutter:
This is the same function as for 'backfeed standard' as it
is always backtracked after cutting immediately to the
beginning of label.
Tear off
edge:
After printing the last label of a print order it is driven
into the tear-off offset. When starting a new print order,
the next label is immediately printed. Because of the
fact that the label is already in the offset, the label is
only printed from beginning of offset position, i.e. at the
definition of label an accordingly large range must be
left free at the top margin of label, because these data
are otherwise not printed.
If a following print order is available before driving into
the tear-off offset, then it is not driven into tear-off offset
but the following label is directly printed.
Peel off:
After printing the label, during driving into dispensing
offset the following label is 'pre-printed', if this is already
available (generated). When releasing a new start signal
(IO dynamic) the already 'pre-printed' label is printed to
the end and when driving into the dispenser offset the
following label is again 'pre-printed'. In case the following
label is not yet available or at the last label of a print
order, the dispenser offset is driven as until now, and
then for the next label before printing the backfeed to the
beginning of label is executed.
Cutter:
After printing the label, during driving into the cutter
offset the following label is 'pre-printed', if this is already
available (generated). After the cut it is not backtracked
but the already 'pre-printed' label is printed to the end
and when driving into the cutter offset the following label
is again 'pre-printed'. If the following label is not yet
available or at the last label of a print order, the cutter
offset is driven as until now, then cut and afterwards the
backfeed to the beginning of label is executed.
Tear off
edge:
This is the same function as for 'backfeed standard' as it
is only driven into the tear-off offset at the last label of a
print order, if no following print order is available.
No backfeed
Optimised backfeed