UBI EasyCoder 601 – Installation Instruction
1
PAPER CUTTER KIT
This leaflet contains instructions on how to fit a Paper Cutter on an
EasyCoder 601 E printer.
The Paper Cutter Kit consists of:
• One cutter unit assembly
• This installation instructions leaflet
The Paper Cutter is power-supplied by the printer and is conse-
quently not dependent on the mains voltage.
The Paper Cutter is intended to cut through continuous non-
adhesive paper strip or through the backing paper between labels.
It must not be used to cut through any kind of adhesive, which would
stick to the cutting parts and rapidly render the cutter inoperable –
possibly also causing damage to the electric motor.
Maximum paper thickness is 175
µ
m (
≈
175 grammes/m
2
) for
normal paper-based materials.
The Paper Cutter replaces the printer's front hatch and can be tilted
down in order to facilitate cleaning and paper load and also to give
access to the optional Memory Card Adapter.
When the Paper Cutter is fitted, it will increase the printer's length
and weight by:
Length .......... :
28 mm
(1.1")
Weight .......... :
≈
1.65 kgs (
≈
3.6 lbs)
The rotating cutting edge will cut through the paper approximately
37 mm (1.5") in front of the printer's tear-off edge. The paper feed
setup should be adjusted accordingly, see page 6.
CAUTION!
For safety reasons, the cutter must not be operated
when in open position.
UBI EasyCoder 601 E
Paper Cutter Kit
Installation Instructions
Edition 2, February 1995
Article No. 1-960348-51
General Information
Information in this manual is subject to change without prior notice
and does not represent a commitment on the part of UBI Printer AB.
© Copyright UBI Printer AB, 1995. All rights reserved. Published
in Sweden.
EasyCoder is a trademark of United Barcode Industries (UBI).
Torx is a registered trademark of Camcar Division of Textron Inc.
