Carl Valentin Spectra II, Service Manual

Page: 50 / 76

Refitting options Spectra II
50 Service Instructions 09.16
7.4 Cutting unit
CAUTION!
Risk of injury, particularly during maintenance, the cutter
blades are sharp!

Switch off the before attaching the cutter!

The cutter may only be used when it is mounted on
the printer!

Do not try to cut any materials which exceed the
maximum width or thickness specifications.

Do NOT touch the area of the moving blades!
D
A
B
D
B
E
C
F
Figure 29
1. Remove tear-off edge (if mounted) and the fixing screws at the
printer front.
2. Remove front plate (if mounted) which is fixed at the printer base.
3. If pre-assembled, remove front plate (C) of cutting unit (A).
4. Hold the cutting unit slightly inclined on the right side in front of the
pressure roller so that the threaded holes of the aluminium profile
have approximately the same height as the through holes at the
cutting unit.
5. Press the cutting unit backwards at the left side.
6. Fix the cutting unit with the screws (D) at the aluminium profile.
7. Insert the plug of cable (E) into the female connector (F) and
fasten it.
8. Fix the front plate (C) with the screws (D) at the side panels of the
cutting unit. Make sure that the front plate with the upper short
chamfer in the slot is placed between the cutter blade and the
square pillar.