Carl Valentin Spectra II, Service Manual

Page: 24 / 76

Replacing Components Spectra II
24 Service Instructions 09.16
5.6 Replacing the Pressure Roller
B
C
A
D
D
E
G
F
Figure 8
1. Turn lever (A) counter clockwise to lift up the printhead.
2. Remove labels and transfer ribbon from the printer.
3. Unscrew screws (D) and then remove tear-off edge (F) if
mounted.
4. Unscrew 2 screws (C) at the bearing cover (B) and then remove
the bearing cover (B).
5. Remove pressure roller (E) from the striker arm (G).
1. Press the pressure roller (E) into the striker arm (G).
Pay attention to the correct position of striker arm pins of the
pressure roller (E).
2. Mount the bearing cover (B) with 2 screws (C) to the bottom side
of sole plate.
3. At reassembly pay attention to a precise fitting of the pressure
roller (E).
4. Remove the possible axial play of the pressure roller by
interlocking the striker arm (G) and the mounted pressure roll (F).
Removing the
pressure roller
Installing the
pressure roller