Carl Valentin Spectra II, Service Manual

Page: 45 / 76

Spectra II Adjustments, settings and alignments
09.16 Serviceanleitung 45
6.11 Oil and Lubricate
NOTICE!
Make sure when oiling and greasing that no lubricants deposit
on photocells, electronic components, circuit boards, printhead
and rolls.
A = Low viscosity oil
B = Grease
A
A
A
Figure 24
A
A
B
Figure 25
In case that dust or other dirt is deposit you have
to clean the lubrication at first with alcohol.
Apply rather in regular intervals (1-2 per year) a
bit of lubricant, as only rarely too much.
Otherwise the surplus of lubricant could settle on
neighbouring components and disturb the
functions.
In case those components should have run it
because of lack of lubricant, exchange these as
soon as possible so the functions of the
components and the printer remain.
Install again all components which you have
dismantled for the lubrication in the correct
position.
Take care e.g. tensions of belt.