Carl Valentin DYNACODE, Operating Manual

Page: 66 / 116

Function menu Dynacode series
66 Operating manual 10.15
Select with the cursor the value for which you need more information
and then press key
.
NJb
= No job
Counter for ignored start signals because the print order was not
active.
NRd
= Not ready
Counter for ignored start signals because the print order was not
ready (stopped or error message).
Prt
= Printing
Counter for ignored start signals, during the device prints/is active.
MS/I
= Manual stopped/interrupted
Stop key onto foil keyboard, panel or in a program was pressed.
ItfI
= Interface interrupted
The print order was cancelled because new data was received by an
interface.
SpedS
= Speed stopped
The print order was cancelled because the measured print speed was
too slow.
Press key
to arrive at the next menu item.
Online/Offline:
This function is activated e.g. if the transfer ribbon is to be changed. It
is avoided that a print order is processed although the module is not
ready. If the function is activated then press the key
to change
between Online and Offline mode. The respective state is indicated in
the display.
Standard: Off
Online:
Data can be received by interface. The keys of the foil
keyboard are only active, if you changed in the Offline mode with key
.
Offline:
The keys of the foil keyboard are still active but received data
are not processed. If the module is again in Online mode then new
print orders can be again received.
Press key
to arrive at the next menu item.
TRB = Transfer ribbon advance warning:
Before the end of transfer ribbon, a signal is send by the control
output.
Warning diameter:
Setting of transfer ribbon advance warning diameter.
In case you enter a value in mm then a signal appears via control
output when reaching this diameter (measured at transfer ribbon roll).
v = Reduced print speed:
Setting of the reduced print speed. This can be set in the limits of the
normal print speed. Additionally there are the following settings:
− : No reduced print speed
0
: Printer stops at reaching the warning diameter and indicates 'ribbon
error'.