Carl Valentin DYNACODE, Operating Manual

Page: 37 / 116

Dynacode series Loading ribbon cassette
10.15 Operating manual 37
5 Loading ribbon cassette
Before a new transfer ribbon roll is loaded, the printhead must
be cleaned using printhead and roller cleaner (97.20.002). For
detailed information, please see page 75.
The handling instructions for the use of Isopropanol (IPA)
must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If
the irritation persists, consult a doctor. Ensure good
ventilation.
5.1 Ribbon coating outside
As for the electrostatic unloading the thin coating of the
thermal printhead or other electronic parts can be damaged,
the transfer ribbon should be antistatic.
The use of wrong materials can lead to printer malfunctions
and the guarantee can expire.

Turn lever (A) 90° in clockwise direction.

Remove ribbon cassette from print mechanics by pulling
handle (B).

Load a new ribbon roll as far as it will go onto unwinding
roll (C).

Load an empty cardboard roll as far as it will go onto
rewinding unit (D).

Insert ribbon according to illustration.

Fix ribbon with an adhesive tape at the empty roll and
tighten it by some turns of the core.

Push ribbon cassette again onto print mechanics and take
care that the ribbon not rip.

Turn lever (A) 90° anticlockwise.
Figure 22
The above illustration shows a left hand printing system. If you are
using a right hand system, then the new roll is to be inserted at the left
and the cardboard core is to be inserted at the right side.