Carl Valentin DYNACODE, Operating Manual

Page: 51 / 116

Dynacode series Function menu
10.15 Operating manual 51
Press key
to arrive at the next menu item.
Print offset:
Indication of distance of the layout (res. the first layout in case more
layouts per cycles are to be printed) to the zero point of machine.
Settings possible either in mm or ms. Place cursor at the mm and/or
ms position, press key to change between mm and ms.
Value range: 1 … 999 mm
Press key
to arrive at the next menu item.
Print position:
Indication of position of print carriage in mm.
Value range: 12 … 93 mm
Press key
to arrive at the next menu item.
Layouts/cycle:
Indication of number of printed layouts per print start (cycle).
Value range: 1 … 25.
Press key to arrive at the next menu item.
Check material speed at print start signal:
Off (Default):
Material speed is only checked if the set offset value is
taken into consideration. It is possible to activate print start signal
although the material is not yet in move. However, until the end the
material speed has to be inside the valid speed sector as otherwise
the print order is cancelled.
On:
Material speed is checked at print start signal. Is the material
speed outside of the valid speed sector then the start signal is
ignored.
Press key
to arrive at the next menu item.
Encoder resolution / material feed per encoder rotation:
his function indicates resolution of used encoder and material feed per
rotation of encoder in mm. These settings help measuring the material
speed.
The material feeding per encoder rotation corresponds for instance, in
a 1:1 translation between the encoder and the roller, to the roller
circumference.
Press key
to arrive at the next menu item.
Material speed:
Indication of material speed (only for reading purposes).