Carl Valentin DYNACODE, Operating Manual

Page: 30 / 116

Installation and Initiation Dynacode series
30 Operating manual 10.15
4.1 Installation of print mechanics at machines
The mounting frame is an option and therefore it is necessary to
order it separately.
At the bottom of the print mechanics are two M8 threads that can be
used to fasten the print mechanics.
Please observe the following conditions:

The maximum thread engagement of the M8 threads is 10 mm.

The print mechanics has to be installed with a distance from
printhead to brake stator of 1...2,5 mm (see illustration).
A distance of 2 mm is recommended.

The best print results can be received if the silicon of printing roll
consists of a hardness of 40 - 50° Shore A (average value of
roughness Ra 3.2 µm).

The print surface has to be installed parallel to the linear
movement of print unit and the focal line of printhead.
Discrepancies to the focal line and cavities in the print surface of
0.2mm can lead to an inferior print quality at these positions.
Figure 20
In case the machine is used without mounting frame, then it is
possible to fix the print module from the top with four M6 screws.
The maximum thread engagement of the M6 threads is 6 mm.
(position of printhead see illustration)
Installation with
mounting frame
Installation without
mounting frame