Cargo Floor B.V.
Byte 14
NL-7741 MK COEVORDEN
Phone:+31 (0)524-59 39 00
www.cargofloor.com
Replacing a cylinder CF500 SL-2 / CF500 SL-C
10-12-2013
/ NL 10 van 16
Mounting the new cylinder
Prior to assembly, all the clamping plates must be cleaned with a steel brush and, in particular, the wire in the
clamping plates. The tread on the bottom of the cylinder and the thread on the piston rod must be cleaned also
with a steel brush before mounting the cylinder. Now grease all the clamping plates with copper grease. Also
grease the thread of all the M16x100 bolts beforehand. Equip all new bolts M16x100 of the clamping plates and
the bolts M16x90 of the piston rod bearing with a tob washer with long tab (fig. 19 en 20).
With the help of two people the new cylinder can be hung on his place now. Again you will have to make a
sideways movement to get past the hydraulic pipes that run underneath the cylinders. First mount the clamping
plate that has been left to the last at demounting by hand. The cylinder can hang now.
Think of your safety: make sure that these two bolts are screwed in deep enough into the threaded hole,
so the cylinder is hanging safely!!
This clamping plate must not yet be firmly tightened (fig. 21 en 22).
Fig. 19
Fig. 20
Fig. 21
Fig. 22
