Version 28.01.2013
USB-NTG1
Pa
ge
6
3.
Installation
Switch off ignition and disconnect the vehicle’s battery! If according to factory rules
disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in
sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
Place of installation is behind the Comand head-unit and at the Audio-Gateway which is
located at the left hand side of the trunk (E-class and CLS) or behind the back seat on the
driver side (SL-class).
3.1.
Connecting the USB-box
Remove the Comand from the dash-board.
Plug harness C3C-AVIR into 10pin Molex of USB-box USBC-M510.
Remove the black MOST®-connector which contains the
optical leads from the rear of the Comand. Remove the
optical insert from the black connector. Remove the vehicle
harness’ optical output lead (T) and connect the optical
input lead of C2C-MBN2 (see arrow on MOST®-connector) instead.
