-23-
Instruction Manual
Bar Code
Scanner
Procedures:
J.
Bar code scanning procedure
1. Aim the red illuminated beam of the scanner directly above the bar code. The red beam should be parallel to
the bar code and the gun should be held 6 to 9 inches from the bar code.
2. With a straight, vertical motion, move the scanner down over the label so that the red beam passes over the bar
code. The illustration below shows where the beam should be aimed for an accurate read of the bar code.
3. When you complete the scan, you will hear a single "good read“ beep. If this does not occur, repeat the scan
again.
