Setting the Time Code
79
Setting the Time Code
The camcorder can generate a time code signal and embed it in your recordings. In addition, the time
code will appear in the recordings output from the HD/SD-SDI terminal (
only) and HDMI
terminal. You can select whether the time code is output from the HDMI terminal (
A
155). You can
also select between a drop frame and non-drop frame time code.
Selecting the Running Mode
You can select the running mode of the camcorder’s time code.
1 Open the [Time Code Mode] screen.
[FUNC.]
>
[MENU]
>
>
[Time Code Mode]
2 Touch the desired option.
• If you selected [
Preset], touch [
K
] and continue to step 3. If you selected [
Regen.],
touch [
X
]; you do not need to perform the rest of this procedure.
3 Touch [Time Code Running Mode].
• If you would like to set the time code’s initial value, see the following section
Setting the Time
Code’s Initial Value
.
4 Touch the desired option and then touch [
X
].
• If you selected [
Free Run], the time code will start running.
Options
(
Default value)
Setting the Time Code’s Initial Value
If you set the running mode to [
Preset], you can set the initial value of the time code.
1 Open the [Initial Time Code] screen.
[FUNC.]
>
[MENU]
>
>
[Initial Time Code]
• The time code setting screen will appear with the orange selection frame indicating the hours.
• To reset the time code to [00:00:00:00], select [Reset] instead.
• Touch [Cancel] to close the screen without setting the time code.
2 Touch [
Í
] or [
Î
] to change the field as necessary.
3 Touch another field you want to change (hours, minutes, seconds, frames).
4 Change the rest of the fields in the same way.
5 Touch [OK].
Operating modes:
[
Preset]
After you select this option, select a [Time Code Running Mode] option. With
[
Rec Run], the time code runs only when recording and scenes on the same memory card will
have a continuous time code; with [
Free Run], the time code runs regardless of the camcorder’s
operation. You can also choose to set the time code’s initial value for either [Time Code Running
Mode] option.
[
Regen.]
The time code runs while recording. Use this running mode to continue from the last
time code recorded on the memory card.
