Canon TX-F, Operation Manual

Page: 47 / 78

7.2 Settings for Printing and Transfer (Page: 2/3)
– 37 –
NOTE: Regardless of the setting, data in memory will be printed/
transferred if the PRINT switch is pressed more than two
seconds.
[MSG] Whether to print the messages entered in section 7.3 with the result
“
ON ”: Message is printed.
“
OFF
”: Message is not printed.
[ECO]
Whether to reduce the size of the printout
“
ON ”: Size of printout will be reduced.
“ OFF ”: Non-reduction
[ How to change the setting]
Press either START switch or PRINT switch.
TRANS Whether to transfer the measurement data to external instrument or
not
NOTE: Please contact Canon representative or distributor when
connecting external instrument to the TX-F.
“ ON ”: Data is output in RS232C interface.
“ OFF ”: For no transfer.
[FMT]
Transfer format
NOTE: For details concerning format, please contact Canon repre-
sentative or distributor.
[How to change the setting]
Press either START switch or PRINT switch.
[BAU] RS232C data transfer speed and data format
9600.8N1
9600:
Transfer speed “ 300/600/1200/2400/4800/9600/
19200 ”
8: Transfer bit “
7/8
”
N: Parity “ E/O/N ”
1: Stop bit “
1/2
”
[How to change the setting]
(1) Turn the roller or press FIXATION switch or LIMITER switch to
select transfer speed or transfer format.
(2) Press either START switch or PRINT switch to change the set-
ting.