Canon Puncher Unit-L1, Installation Procedure

Page: 34 / 40

Chapter 1
26
F-1-75
<Finisher-R1>
Fit the cable clamp [2] to the host machine, and route the interface cable [1] through it.
F-1-76
<Saddle Finisher-Q2/Saddle Finisher-Q4>
1) Detach the punch lower front cover once; then, remove the front and rear stepped screws (1 pc. each), and separate
the puncher unit and the host machine.
2) Mount the lower front extension cover [1] using a screw [2] (RS tightening; M3x8) and anther screw [3] (tapping;
M4x12).
3) Mount the front foot cover [4] using a screw [2] (RS tightening; M3x8).
4) Mount the rear foot cover [5] using a screw [2] (RS tightening; M3x8).
F-1-77
5) Connect the puncher unit and the host machine; then, secure them at the front and the rear
using stepped screws (1 pc. each).
6) Mount the punch lower front cover.
7) Connect the finisher and the host machine with the interface cable [1].
[1]
[1]
[2]
[5]
[4]
[1]
[2]
[3]
[2]