Canon Puncher Unit-L1, Installation Procedure

Page: 32 / 40

Chapter 1
24
F-1-70
C. Adjusting the Tilt
1) Loosen the 2 fixing screws [1] each on the front and rear casters on the delivery side of the finisher.
2) To decrease the gap between the punch unit and the host machine, turn the adjusting bolt [2] in the direction of
the arrow A (A full turn of the adjusting bolt will increase the height of the finisher by 1.75 mm.). Refer to the index
on the caster while turning the bolt, and perform this for both front and rear casters.
3) To increase the gap between the puncher unit and the host machine, turn the adjusting bolt [2] in the direction of
the arrow B (A full turn of the adjusting bolt will decrease the height of the finisher by 1.75 mm.). Refer to the index
on the caster while turning the bolt, and perform this for both front and rear casters.
F-1-71
D. Making Checks After Adjustment
1) Check to see once again the that the difference in height between the finisher and the puncher unit and the tilt are
as indicated; otherwise, make adjustments once again.
2) When done, tighten the 2 fixing screws [1] each on the casters.
3) To prevent the adjusting bolts from becoming loose during transit for possible relocation after installation, tighten
the bolts [2] 90 deg in the direction of the arrow. Take care, however; excess tightening will affect the height/tilt.
F-1-72
4) Attach the spanners to the back of the front cover using a screw.
B
[1]
A
[2]
B
[1]
A
[2]
[1]
90
[2]