Canon Puncher Unit-L1, Installation Procedure

Page: 20 / 40

Chapter 1
12
rubber sheet as it is. Be sure that the rubber sheet you
may be attaching to the pickup surface of the puncher
unit is a new one.
10) Remove the 2 screws [1], and detach the 2 fixing
plates [2] and [3] of the host machine.(For the
Finisher-T1 or the Saddle finisher-T2, it is not
necessary to remove them.)
<Finisher-Q1/Finisher-Q3/Saddle Finisher-Q2/
Saddle Finisher-Q4>
F-1-21
<Finisher-R1/Saddle Finisher-R2>
F-1-22
1.3.2 Connecting to the
Finisher
0003-0207
1) In the case of the Finisher-Q1/Finisher-Q3, remove
the 2 screws [1], and detach the inlet guide [2];
then, remove the 4 screws [3], and detach the right
cover [4]. (Skip this step if it has already been
removed.)
F-1-23
2) Fit the 2 mounting stepped screws [1] to the pickup
assembly of the finisher.
<Finisher-Q1/Finisher-Q3/Finisher-R1>
F-1-24
<Saddle Finisher-Q2/Saddle Finisher-Q4/Saddle
Finisher-R2/Finisher-T1/Saddle Finisher-T2>
F-1-25
3) Route the connector cable [1] of the puncher unit to
the rear; hold it as shown, and hook the hole [2] of
the joint assembly on the 2 mounting stepped
screws.
[1]
[1] [2]
[3]
[2]
[3]
[1]
[1]
[1]
[3]
[4]
[3]
[2]
[1]
[1]