Canon Puncher Unit-L1, Installation Procedure

Page: 31 / 40

Chapter 1
23
F-1-67
2) Remove the 3 screws, and detach the front cover. (Skip this step if it has already been removed.)
3) From the back of the front cover, remove the fixing screw, and detach the spanners [1].(The figure shows the
Finisher-R1.)
F-1-68
<Saddle Finisher-Q2/Saddle Finisher-Q4/Saddle Finisher-R2/Saddle Finisher-T2>
1) Open the front cover; then, from the back of the front cover, remove the fixing screw, and detach the spanners [1].
(The figure shows the Saddle Finisher-Q2/Saddle Finisher-Q4.)
F-1-69
B. Adjusting the Height
1) Loosen the 2 fixing screws [1] each on the front and rear casters on the pickup side of the finisher.
2) To increase the height of the finisher and the puncher unit, turn the adjusting bolt [2] in the direction of the arrow
A (A full turn of the adjusting bolt will increase the height of the finisher by 1.75 mm.). Refer to the index while
turning the bolt, and perform this for both front and rear casters.
3) To decrease the height of the finisher and the puncher unit, turn the adjusting bolt [2] in the direction of the arrow
B (A full turn of the adjusting bolt will decrease the height of the finisher by 1.75 mm.). Refer to the index while
turning the bolt, and perform this for both front and rear casters.
[3]
[4]
[1]
[1]
[2]
[1]
[1]