Canon Puncher Unit-L1, Installation Procedure

Page: 17 / 40

Chapter 1
9
1.3 Installation Procedure
1.3.1 Disconnecting the
Finisher from its Host
Machine
0003-0206
If a finisher has been installed, you will have to
disconnect it from its host machine before installing
the puncher unit. If you are installing the finisher
and the puncher unit at the same time, on the other
hand, install the finisher as instructed in "Preparing
for the Installation of the Finisher"; and then, go
through the steps under "Connecting to the
Finisher" herein.
1) Turn off the host machine, and disconnect the
power plug (from the power cutlet).
2) Disconnect the interface cable [1] of the finisher
from the host machine.
<Finisher-Q1/Finisher-Q3/Saddle Finisher-Q2/
Saddle Finisher-Q4/Finisher-T1/Saddle Finisher-
T2>
F-1-8
<Finisher-R1/Saddle Finisher-R2>
Free the interface cable [1] from the cable clamp [2].
F-1-9
3) In the case of the Finisher-Q1/Finisher-Q3/
Finisher-R1, remove the foot cover and the
extension cover (if Finisher-Q1/Finisher-Q3).(For
the Finisher-T1, it is not necessary to remove
them.)
<Finisher-Q1/Finisher-Q3>
Remove the screw [1], and detach the lower front
extension cover [2].Remove the screw [1], and detach
the front foot cover [3].
F-1-10
<Finisher-R1>
Remove the screw[1], and detach the front foot cover
[2].
F-1-11
4) Remove the front cover.
[1]
[1]
[2]
[3]
[1]
[2]
[2]
[1]