Canon PIXMA MP830, Service Manual

Page: 13 / 85

Note: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROM information print). If the
waste ink amount is 7% or more, also replace the ink absorber kit (QY5-0153) when replacing the logic board ass'y. [See Section 3-3.
Adjustment / Settings, (6) Service mode , for details.]
2-3. Fax Errors
For errors other than those listed below, please refer to the " G3 / G4 Facsimile Error Code List (Rev. 2). "
(1) User error codes
(2) Service error codes
blinking hard-power-on.
Alarm LED lit RAM error [6300] The RAM error occurred in the RAM check at hard-
power-on. - Logic board
Error code TX / RX Meaning
#001
TX Document jam
#003
TX / RX Document is too long, or page time-over
#005
TX / RX Initial identification (T0 / T1) time-over
#009
RX Recording paper jam, or no recording paper
#012 TX No recording paper at the receiving machine
#017
TX Redial time-over, but no DT detected
#018
TX Auto dialing transmission error, or redial time-over
#022
TX Call failed (no dial registration)
#037
RX Memory overflow at reception of an image
#085 TX No color fax function supported in the receiving machine
#099
TX / RX Transmission terminated mid-way by pressing the Stop/Reset button
#995
TX / RX During TX (sending): Memory transmission reservation cancelled
During RX (receiving): Image data received in the memory cleared
Error code TX / RX Meaning
##100
TX Re-transmission of the procedure signal has been attempted the specified number of times, but failed.
##101
TX / RX Sender's modem speed does not match the receiving machine.
##102 TX Fallback is not available.
##103
RX EOL has not been detected for 5 seconds (or 15 seconds in CBT).
##104
TX RTN or PIN has been received.
##106
RX The procedure signal has been expected for 6 seconds, but not received.
##107
RX Fallback is not available at the sending machine.
##109
TX After DCS transmission, a signal other than DIS, DTC, FTT, CFR, or CRP has been received, and re-transmission of the
procedure signal has been attempted the specified number of times but failed.
##111
TX / RX Memory error
##114
RX RTN has been received.
##200
RX A carrier has not been detected for 5 seconds during image reception.
##201
TX / RX DCN has been received in a method other than the binary procedure.
##204 TX DTC has been received even when there is no sending data.
##220
TX / RX System error (main program hang-up)
##224
TX / RX An error has occurred in the procedure signal in G3 transmission.
##226
TX / RX The stack pointer has shifted from the RAM area.
##229
RX The recording area has been locked for 1 minute.
##232
TX The encoder control unit has malfunctioned.
##237 RX The decoder control unit has malfunctioned.
##238
RX The print control unit has malfunctioned.
##261
TX / RX A system error has occurred between the modem and the system control board.
1-7