Canon MF512 Series, User Manual, Page: 667 / 913

Calendar Type
Sharpness
Seven Levels
Register Unit Name (Fax)
Register the name of a company or person ( Registering the Fax Number and Unit Name(P. 141) ). The
registered name is sent as sender information to the destination ( TX Terminal ID(P. 659) ).
ECM TX
Enable or disable error correction mode (ECM). ECM checks for fax data errors and corrects them. To reduce
errors on received faxes, see ECM RX(P. 661) .
Off
On
<Menu> <Fax Settings> <TX Function Settings> <ECM TX> <On>
● ECM must be enabled on both the machine and the other fax device because error checks are
performed on both the sending and receiving devices.
● Even when ECM is enabled, errors may occur due to telephone line conditions.
● It may take a longer time than usual to process data when ECM is enabled because the error checks
and corrections are performed while the data is transmitted.
Set Pause Time
*1
For example, when you make calls by dialing "0 - (pause) - (telephone number)", 0 is dialed first and then a few
seconds later, the telephone number. When sending faxes overseas, you need to specify destinations by dialing
"(international access code) - (country code) - (area code) - (fax number)" but consecutive numbers that are
input without pauses may not be recognized correctly. In this case, try adding a pause after the international
access code or the fax number. If the code or the number is still not recognized correctly, change the duration
of the pause. For instructions on how to enter a pause, see step 3 on Sending Faxes (MF515x)(P. 148) .
1 to 4 to 15 (sec.)
<Menu> <Fax Settings> <TX Function Settings> <Set Pause Time> Specify the duration of
pause <Apply>
Auto Redial
*1
Specify settings for Auto Redial, a function that automatically redials the fax number after several minutes if the
first attempt fails because the line is busy. You can specify how many times the machine redials and the interval
between redials.
Off
Setting Menu List
658