Canon iR C6800 Series, Service Manual

Page: 394 / 1404

Chapter 7
7-128
3) After freeing the highvoltage connector cable [1]
from the 2 wire saddles [2], fix the cable in place using
the cable hook [3].
F-7-350
4) Take out the process unit cover [1] from the
shipping box, and detach the drum stop tool [2] from
the back of the cover.
F-7-351
5) While forcing the drum stop tool [3] against the
drum fixing member [2] of the drum shift [1], remove
the fixing screw [4].
1: Be sure to match the protrusion [5] of the drum
fixing member and the protrusion [6] of the drum stop
tool.
F-7-352
2: When drawing out the process unit, be sure to find
out the position of the protrusion [1] of the drum
fixing member in relation to the marking [2] on the
drum flange.
In the example in the figure, the marking [2] on the
drum flange is at "." on the left and at ".." on the right
in relation to the protrusion [2] of the drum fixing
member.
Moreover, when you close the process unit, it is
important that the spatial relationship between the
protrusion of the drum fixing member and the
marking on the drum flange is as it was before you
drew out the unit.
6) Using a pair of fine pliers, remove the drum fixing
member [1].
F-7-353
[1]
[2]
[3]
[1]
[2]
[6]
[3]
[4]
[5]
[2]
[1]
[1]