Canon iR C3200 Series, Portable Manual

Page: 50 / 170

Chapter 3
3-6
0410 The rotation of the K laser
scanner motor is faulty.
The motor lock signal remains in an unlock state for
1 sec or more while the laser scanner motor is in
operation.
E202 A fault has occurred in detecting the No. 1 mirror home position.
0000 The No. 1 mirror base moves in
reverse but does not move to its
home position.
The home position sensor does not go ON within a
specific period of time.
0001 The No. 1 mirror base moves
forward but does not move from
its home position.
The home position sensor does not go OFF within a
specific period of time.
E220 A fault has occurred in activating the scanning lamp.
0000 The intensity of the scanning
lamp has dropped.
During shading adjustment at time of power-on, the
intensity detected by the CCD is below a specific
level.
E240 The communication between the main motor controller and the DC controller is faulty.
0000 There is a fault in the serial communication between
the main controller and the DC controller.
0002 While print is under way, there is no appropriate
response from the DC controller within a specific
period of time.
E243 The control panel is faulty.
0000 There is a fault in the communication between the
controller and the control panel.
E248 The EEPROM on the reader controller PCB is faulty.
0000 The ID stored in EEPROM (read when the main
power is turned on) and the ID stored in the flash
ROM fail to match.
E302 A fault has occurred in relation to shading correction.
0000 A time-out has occurred in
shading operation.
The shading processing does not end 1 sec after it
has started.
0001 A time-out has occurred in gain/
offset correction by the analog
processor.
The gain/offset correction (setting operator) by the
analog processor does not end 1 sec after it has
started.
E315 The image data is faulty.
0001 A time-out condition has occurred in encoding/
decoding processing of image data.
0008 The ASIC (used for compression/expansion
processing) on the image conversion board is faulty.
While encoding is under way, a time-out condition
occurs (i.e., there is no response within 30 sec).
Code Detail Description Timing of detection