Canon iPF825, Service Manual

Page: 287 / 316

Chapter 8
8-17
2905 Mail box full.
Delete unwanted data
on your computer
to resume printing.
Press Stop
to cancel printing. A job save has been executed when the
available size of the permanent area of the
hard disk space was lost.
Cancel the job. Reorganize data.
The mail box
is full.
Delete unwanted data
from your computer
to continue.
2906 Mail box full.
Cannot save. Delete
unwanted data on
your computer to
resume printing.
Press Stop to cancel
printing. The 101st job has been received when 100
jobs are already saved in the permanent
area of the hard disk space. Reorganize data.
Too many jobs for
mail box.
Delete unwanted data
from your computer
to continue.
2907 Mail box full.
Delete unwanted data 100 jobs are already saved in the
permanent area of the hard disk space
(Warning). Reorganize data.
Maximum jobs
stored. Delete
unwanted data.
2908 Hard disk error.
Press OK to reformat
HDD format error 1. Format as instructed by the on-panel
message.
2. Replace the HDD.
Hard disk error.
Press OK to format
HDD and restart the
printer (Takes 40
min). This deletes
all HDD data.
(cannot be canceled)
Hard disk error.
Will format HDD and
restart the printer
(Takes 40 min). This
deletes all HDD data
(cannot be canceled)
2909 File read error.
Turn off printer,
wait a while, and
turn it on again.
Invalid files
will be deleted.
HDD file error Restart the printer.
(The file in error is deleted, but the
printer will recover normally when it is
restarted.)
290A Hardware error.
03130031-290A
Turn off printer,
wait, then
turn on again. HDD not connected.
HDD was not detected at startup. Connect the HDD/ Check the harness.
Replace the HDD.
2918 Power On
Again
Cassette Sensor
Detection Error Cassette detection sensor detection failure
(cassette presence/absence sensor)
No cassette has been detected during
cassette pickup. 1. Check to see if the cassette itself is
properly loaded.
2. Check and replace the sensor (I/O
mode).
291A Roll sensor
cannot detect.
Turn on printer
again.
Power On
Again
Roll Sensor
Detection Error Roll sensor detection failure
Could not detect the roll unit. 1. Check the roll unit, and remove,
install or replace the roll unit.
2. Check I/O mode (roll unit
detection).
291B Hardware error.
03130031-291B
Turn off printer,
wait, then
turn on again.
Power On
Again
Lift Motion
Timeout Lift shift timeout
A lift operation has been executed, but no
sensor has been detected or a sensor has
remained detected. 1. Switch off the printer, then back on.
2. The carriage cannot travel to the lift
drive position.
3. The lift drive cam is not engaged.
4. Faulty lift drive sensor
5. Faulty lift drive motor
291D Hardware error.
03130031-291D
Turn off printer,
wait, then
turn on again.
Power On
Again
Hardware Err 1
03130031-291D Spur cam sensor detection failure Check the spur cam sensor in I/O
mode.
-If OK, check the lifter drive system.
-If NG, replace the sensor.
Code
(last 4 digits)
Panel display
(Large LCD)
Panel display
(Small LCD)
Explanation/Detection sequence Remedial Action