Canon imagePROGRAF iPF6200, User Manual

Page: 75 / 734

Control Panel
Paper Details
Setting Item Description, Instructions
Roll DryingTime Specify the time to wait for the ink to dry for each sheet.
Scan Wait Time Specify the time to wait for the ink to dry between each scan
in bidirectional printing, in consideration of how quickly the ink
dries. Note that printing will take longer if you specify a wait
time.
Feed Priority Specify exact paper feeding, if desired. Normally, select
Automatic . Choose Print Length if you prefer to feed the
paper an exact amount. However, note that choosing Print
Length may result in slight banding in the direction of Carriage
scanning.
Adjust Length Displayed if Feed Priority is Print Length .
Adjustment relative to the amount of stretching or shrinkage of
the current paper.
Enter either the adjustment results from
Print Pattern or the
discrepancy that you measured (as a percentage).
For paper that tends to stretch, increase the feed amount by
choosing a higher adjustment value. For paper that tends
to shrink, decrease the feed amount by choosing a lower
adjustment value.
Head Height Adjust the Printhead height. (→P.576)
Skew Check Lv. If you print on Japanese paper (washi) or other handmade
paper that has an irregular width, choose
Loose for a higher
skew detection threshold, or choose Off to disable skew
detection. However, if paper is loaded askew when detection is
Off , note that paper jams or Platen soiling may occur.
VacuumStrngth Specify the level of suction that holds paper against the Platen.
(→P.587)
NearEnd RollMrgn Specify the minimum margin at the leading edge of roll paper to
ensure better printing quality at the leading edge.
Note that if you choose
3mm , it may lower the printing quality
at the leading edge and affect feeding accuracy. The printed
surface may be scratched, and ink may adhere to the leading
edge. It may also cause the Platen to become soiled.
Cut Speed Choose the cutting speed. If you use adhesive paper, choosing
Slow helps prevent adhesive from sticking to the cutter and
keeps the cutter sharp.
(The paper type is
displayed here.)(*1)
Trim Edge First If a roll is loaded, the end of the paper will be cut.
Choose
On to have 40 mm (1.6 in) cut off the leading edge of
the roll after you load the roll. Scraps are then removed.
When
Automatic is selected, if the left and right side of the
leading edge of the roll are uneven (by 3 mm [0.12 in] or more),
the edge is cut an amount relative to the slant to ensure a
straight edge after you load the roll. Scraps are then removed.
If the unevenness is less than 3 mm or if
Off is selected, the
edge is not cut and scraps are not removed.
Printer Parts 61