Canon imagePRESS Server B5000, Configuration And Setup

Page: 116 / 128

In Setup In Configure
Mismatch Timeout Timeout
Cancel Processing Upon Mismatch Cancel job processing after time out expires
Note: Enable Suspend on Mismatch
(found in Setup on the printer control panel) and
Enable Job Mismatch
(found
in Configure) are the same setting. Configuration and Setup documents this feature as
Enable Suspend on Mismatch
in the Setting up from the printer control panel chapter.
Workflow example 1
Assumptions
Enable Suspend on Mismatch
is
On
Mismatch Action is set to Cancel
Timeout
is set to
5 minutes
If a mismatch job occurs, the following happens:
1
An error message about the mismatch appears in Command WorkStation, but does not appear on the printer
control panel.
Note:
The message does not appear on the printer because the job was never sent to the printer.
2
You have the timeout period (default is 5 minutes) to correct the mismatch, for example, by loading the correct
size of paper.
3
If no action is taken, after the timeout period (default is 5 minutes) the message disappears and the job is
canceled.
Note: If you look at the Job Log in Command WorkStation, the job appears as canceled.
Workflow example 2
Assumptions
Enable Suspend on Mismatch
is
On
Mismatch Action
is set to
Suspend
Timeout
is set to
5 minutes
If a mismatch job occurs, the following happens:
1
An error message about the mismatch appears in Command WorkStation, but does not appear on the printer
control panel.
Note:
The message does not appear on the printer because the job was never sent to the printer.
2
You have 5 minutes (the timeout period) to correct the mismatch, for example, by loading the correct size of
paper.
Configuration and Setup
Administration
116