Canon FY8-13HR-000, Service Manual

Page: 86 / 105

COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2001
CHAPTER 5 TROUBLESHOOTING
5-5
1.4 Preliminary On-site Checkout
Perform a preliminary on-site checkout to eliminate obvious problems such as loose or
missing cables and connectors, or loosely seated printed circuit boards.
1.4.1 Checking Interface Cables
Before you open the iR-M1 to check internal components:
• Verify that the copier interface cable is plugged into the copier interface port and con-
nected to the copier (see “Connecting to the copier” on page 3-3).
• If a PC is connected, check that the parallel cable is connected to the PC and the iR-M1
parallel port (see “Connecting a PC to the parallel port” on page 3-7).
• Check that the network cable is connected to the proper port on the back panel (see
“Connecting to the network” on page 3-5).
• Make sure the power cable is plugged into the wall supply and that the iR-M1 is pow-
ered on (see “Preliminary checkout” on page 3-1).
F05-104-01 Back panel of the iR-M1
Not used
Not used
Not used
RJ-45 port for
10/100BaseT
twisted pair
Parallel port
Copier interface port
Power switch
Power connector