![background image](http://html.mh-extra.com/html/canon/elura10-a/elura10-a_service-manual_58449127.webp)
ELURA20 MC A, ELURA10 A
CHAPTER 4. DISASSEMBLING ADJUSTMENT
4-32
2-5-2 CCD Void Pixel Correction (Manual)
Note)
1) Use the full scan monitor for this adjustment.
Preparation)
1)
Take the product condition for this adjustment.
2)
Adjustment conditions
Program AE
: LOW LIGHT
AF
: OFF
Image stabilizer
: OFF
Electronic zoom
: OFF
M.EQ.
Monitor TV
Procedure)
(1) Before switching to the service mode, press the data screen key on the LANC remote controller to turn OFF the data screen.
(2) Select the service mode, and then set up the CCD void pixel correction adjustment mode (manual) following the table given below.
(3) Press the data screen key on the LANC remote controller to turn OFF the data screen.
(4) Move an unused marker (arranged at left of screen) to the position where a pixel is missing. The movement is done by changing
the data at the address corresponding to each marker.
The addresses corresponding to the markers are shown in Fig.4-23
Notes)
1)
The odd-numbered marker is for odd-numbered lines (ODD) and the even-numbered marker is for even-numbered lines (EVEN).
If the marker cannot be aligned with a pixel void position, use the marker for a different line.
A
(Normal field of view)
B
E
C
D
F
G
Area
DT Angle of section
A
00 No shift (normal angle)
B
01 Sectioning at top center
C
02 Sectioning at bottom center
D
03 Sectioning at top right
E
04 Sectioning at bottom right
F
05 Sectioning at top left
G
06 Sectioning at bottom le
ft
Electronic
Vibration-proof
Pixel area
CCD
*Angle of CCD for selection
Fig. 4-22
ST EP
PROCEDURE
MONIT OR
Microcomputer operation
CCD PIXEL MISSING COMP.
PG
BK
MD ADDR
DT
ST
1
1) Make the setting shown at right.
5
3
WR
**00
FF
WAIT
2) Press the ST ORE key.
↑
↑
RD
↑
↑
OK
High address "FF" is set up.
2
1) Make the setting shown at right.
5
2
RD
FF00
00
WAIT Entering the CCD pixel missing compensation
mode is complete. (AGC MAX., Iris close)
3
1) Make the setting shown at right.
5
3
WR
FFFF
06
WAIT See table below for angle of CCD.
2) Press the ST ORE key.
↑
↑
RD
↑
↑
OK
for selection.
(Unused marker is appeared at view angle of
"Area"G.)
Summary of Contents for ELURA10 A
Page 150: ...5 16 ELURA20 MC A ELURA10 A CVF Unit Section 15 14 9 8 13 12 11 6 5 1 2 3 4 7 16 17 10 ...
Page 152: ...5 18 DMC II Mechanical Chassis Section 1 1 4 2 3 6 7 10 11 12 5 4 2 3 8 9 Slide Chassis Ass y ...
Page 158: ...5 24 DMC II Mechanical Chassis Section 4 REAR FACE 1 2 2 5 6 7 8 9 5 10 11 12 1 13 14 3 4 ...